EasyManua.ls Logo

Silvercrest STK 650 B2 - Cleaning and Care; Overheating Protection

Silvercrest STK 650 B2
92 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20 
GB
IE STK 650 B2
Overheating protection
If the appliance overheats, the overheat protection automatically switches off the
heating element inside the appliance. The On/Off switch 8 remains lit, but the
appliance no longer heats up.
The overheating protection is activated if the appliance is switched on if the
jug3 contains no or not enough water.
If the overheating protection has switched the heating element off, please
proceed as follows:
Allow the appliance to cool down.
Press the reset button 6 on the bottom of the jug 3. The appliance can
now be used again.
Cleaning and care
DANGER! ELECTRIC SHOCK!
Always remove the plug before cleaning the appliance. There is a risk of
electric shock! Allow the appliance to cool down. Risk of burns!
Never immerse the appliance in water or other liquids. There is a risk of
electric shock! The appliance may be irreparably damaged.
To achieve the best tea-brewing result every time, the appliance should always
be cleaned after use. This prevents:
the combination of limescale and tannins, caused by boiling water and
brewing tea, from affecting the functioning of the tea maker;
the jug from taking on the flavour of particularly aromatic teas and
affecting other varieties of tea if the tea maker is used regularly.
Clean the jug 3 of the tea maker with a damp cloth. Add a little mild
detergent to the cloth to remove stubborn dirt. Rinse out the jug 3
afterwards with plenty of clean water to remove any detergent residue. You
can clean the recess on the bottom of the jug 3 well with a washing up
brush.
CAUTION! PROPERTY DAMAGE!
Do not use abrasive, chemical or caustic cleaning agents. These can
irreparably damage the appliance!
Clean the brewing system with hot water and washing-up liquid:
The brewing chamber 0 and the sieve w can be cleaned with a washing
up brush. Clean the riser pipe q using the riser pipe brush 9. Rinse the
entire brewing system after cleaning with clear water to ensure that no
detergent residues remain.
IB_337246_STK650B2_LB8.indb 20 06.05.2020 09:00:13

Table of Contents

Related product manuals