10
SWCD 1000 A1
GB
IE
Removing attachments
■ First switch the appliance off and allow it to cool down..
■ Press the release button “push” 7 and turn the attachment anti-clockwise .
■ The attachment can now be removed by pulling it out of the attachment inser-
tion slot 1.
Switching on /off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
– “0“ The appliance is switched off
– “1“ for a reduced air-fl ow strength with heat
– “2“ for a high air-fl ow strength with heat
■ You switch the appliance off by sliding the level switch 3 to the position “0”
(= appliance off ).
■ To fi x the styling, you can use the slide switch Cool Shot 2. The styling will
be fi xed by the cool air stream:
– During operation, slide the slide switch Cool Shot 2 upwards.
The air fl ow will be cooler.
– When you want to deactivate the cool air stream, slide the slide switch
Cool Shot 2 downwards.
Using the attachments
Large round brush
11
This attachment gives the hair more volume or large curls.
■ Wind a slightly damp strand of hair around the large round brush q.
■ Switch the appliance on at level 1 or 2.
■ When the strand is dry, slide the slide switch Cool Shot 2 upwards.
Wait until the strand has cooled.
■ Unwind the large round brush q from the strand.
■ Proceed with the other strands in the same way.
IB_87966_SWCD1000A1_FI_SE_DK.indb 10IB_87966_SWCD1000A1_FI_SE_DK.indb 10 08.03.13 09:1008.03.13 09:10
To Next Page
Loading...
