Silvercrest SWED 100 A1 User Manual

SilverCrest SWED 100 A1
English - 119
 Briefly press the "POWER" button (6) to switch off the alarm tone or
press the "SNOOZE" button (2) to postpone the alarm for about 5
minutes The "ALARM" symbol (27) flashes. If you have previously
chosen the buzzer as the alarm tone, you can switch on the radio during
the snooze period. The alarm sounds again after the snooze period of 5
minutes. If you briefly press the "BAND" button (8) during these 5
minutes, the "SNOOZE" function is switched off, but the alarm function
remains activated.
 To deactivate the alarm function, press the "ALARM" button (10) again.
The "ALARM" symbol (27) is no longer indicated.
Even if the alarm function is activated, you can still use
the device as usual. Please note:
 Alarm with radio:
The alarm function always automatically uses the last
frequency, frequency band and volume set.
 Alarm with buzzer:
The alarm function always automatically uses a
preset volume. This volume cannot be changed.
Enabling/disabling the button lock
Press the "LOCK" button (12) for approximately one second to enable the
button lock of the world receiver. The "LOCK" symbol (26) now flashes on
the display. Further operation is only possible if you disable the button lock
by pressing the "LOCK" button (12) again for approximately one second.
The "LOCK" symbol (26) no longer flashes on the display (5).
While the alarm sounds, the "SNOOZE" button (2) can be pressed even
when the button lock is enabled.

Silvercrest SWED 100 A1 Specifications

General

Brand	Silvercrest
Model	SWED 100 A1
Category	Radio
Language	English