11 GB
Operation
mDanger of burns! The lid
3
must remain
closed when pouring hot water. Otherwise,
hot water or steam could escape over the rim
causing burns.
Placing the product
Keep the power cord
6
as short as possible.
Wrap the excess power cord onto the cord
storage
8
(bottom of the base
9
).
Guide the power cord
6
through the power
cord guide
7
.
Place the base
9
on an even, stable surface.
Maintain a safe distance to walls and
cupboards to avoid damages caused by rising
steam.
Boiling water
Fill the water kettle
12
with water through the
lid’s
3
filler flap
2
.
Place the water kettle
12
onto the base
9
.
Push the I/O switch
4
into the I position.
The LED ring
10
(on the bottom of the water
kettle
12
) lights up. The colour of the LED ring
changes with the water temperature.
Colour Temperature (approx.)
Green ≤ 50 °C
Blue 51–70 °C
Purple 71–80 °C
Yellow 81–90 °C
Red > 90 °C
The product automatically turns off when the
water is boiled.
Cleaning and care
mWARNING! The product shall not be
immersed in water or other liquids. Do not
hold the product under running water.
Always disconnect the product from the power
supply before cleaning.
Check the product prior to each use for visible
signs of damage.
Cleaning
Do not use any abrasive, aggressive cleaners
or hard brushes to clean the product.
Clean the product with a slightly damp cloth.
Use a mild detergent, if necessary.
Rub all parts dry with a clean cloth.
Care
Cleaning the strainer
1
Fig.
Remove the lid
3
.
B
Gently pull on the strainer‘s
1
clip to release it.
C
Rinse the strainer
1
with fresh
water.
–
Place the strainer
1
with its top
edge on the top of the water kettle
12
.
D
Press the strainer
1
firmly into
position.
E
Removing calcifications
Limescale reduces the efficiency of the product
and increases energy consumption. Check the
product regularly for limescale deposits.
Fill the water kettle
12
with a vinegar solution
(5 to 15 %).
Push the I/O switch
4
into the I position.
Wait for the product to turn off automatically.
To Next Page
Loading...
