Silvercrest SWV 300 C1 - WPS - Connect to the AP (Router Mode)

SilverCrest SWV 300 C1
202 - English
WPS - Connect to the AP (Router Mode)
This is the easiest way to establish a connection to the AP. First, check whether your end device supports
WPS. For further details, please read the operating instructions for your end device.
1. Press the WPS button (9) on the wifi range extender for at least 3 seconds. The Power/WPS LED (2)
now flashes for approx. 2 minutes.
2. Within these 2 minutes, please press the connection button (WPS) on your end device. For further
details, please read the operating instructions for your end device.