SilverCrest SWV 733 B1
English - 27
1. You can configure the Dual-Band Range Extender via the network cable. If you want to
configure the Dual-Band Range Extender via the network cable, you must connect the Dual-
Band Range Extender to your computer. Use the network cable provided with the device for
this purpose. Insert one end of the network cable into the WAN/LAN socket (5) of the Dual-
Band Range Extender and the other into the LAN socket of your computer.
2. Alternatively you can perform the configuration via a wireless network. To do so, start the
search for available wireless networks on your computer. The host network SWV 733 B1
2.4G or SWV 733 B1 5G is displayed in the list of available wireless networks. Select the
host network SWV 733 B1 2.4G or SWV 733 B1 5G and click on the Connect button
to wirelessly connect to the Dual-Band Range Extender. The Dual-Band Range Extender
comes secured with a host password. After entering the host password
(9426824723156819), the Connect without configuring the network option
must be clicked on. The “Limited network connection” message is displayed, if necessary.
Now open the Internet browser on your computer. Enter https://repeater.setup in the
address line of your Internet browser and confirm the entry with the Enter key.
To Next Page
Loading...
