Silvercrest Z30412-IT - Programming the Overload Warning Value

To Next Page

To Previous Page

192 GB/MT

the time at which the maximum power

consumption was measured, along

with the power factor in cos phi.

Note: The maximum power consump-

tion is stored until a higher value is

measured. Only then is the older val-

ue overwritten in the meter‘s memory.

 Press and hold down the FUNCTION

button

for approx. 3 seconds to

erase the stored values.



Programming the

overload warning value

Note: In addition to a maximum value

for the power consumption (W), you can

program a maximum value for the current

(A). Here again, the energy cost meter

carries out further measurements if the

maximum value is exceeded.

66149_silv_Energiekosten-Messgerät_Content_ES-IT-PT-GB.indd 192 25.05.11 12:21