Silverlit DIGIT PRO Series - Getting Started; Index to Parts

"This product is in compliance with the
essential requirements and other
relevant provisions
of Directive € €
1999/5/EC."
A WARNING:
CHOKING HAZARD — Small parts.
Not for Chitdren under 3 years.
Getting Started
Batteries:
‚The 1:16 Ferrari F430 is powered by 6 V Ni-Cd battery pack.
-The Transmitter is powered by 4 x 1,5 V "AA" size batteries.
Battery Installation: Transmitter
Make sure the power switch is on "OFF" position
1.
Use
a
phillips
head(Cross-Head)
screwdriver
to
loosen
screw
in
counter-clockwise
(pic.1)
2.
Insert
new
"AA"
size
batteries
with
"+"
&
"-"
signs
as
shown
inside
battery
compartment.(pic.2)
Close
the
battery
cover
using
a
phillips
head(Cross-Head)
screwdriver.
Ferrari
“Produced under license of Ferrasl Spa. FERRARI, the
PRANCIHG HORSE device, all azsoclated logos and
distintiva designs ara lradertatks of Fete) Spa The body
designs of the Ferrari cars aro protseted as Ferrari property
FCC Statements under design, markemark and trade dress regulations”
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and — ;
2)This device must accept any interference received, including interference that may cause undesired operation.
4x 15 Y "AA Sizo
batteries
NOTE: This equipment has been tested and found to comply with the fimits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This f
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference wilt not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected,
- Consult the dealer or an experienced radio/TV technician for help.
Index to parts
Battery Installation: 1:16 Ferrari F430
Make sure the power switch is on "OFF" position
1. Make the "LOCK" turn to open position. (pic,3)
2.
insert
charged
battery
pack
inside
the
battery
compartment.
(pic.4)
Then
turn
the
lock
to
"LOCK"
position.
N,
Screw up the antenna
with
the
transmitter
6
V
Ni-Cd
Battery Pack
LED
indicator
Charging Battery Pack:
The
6V
battery
pack
has
to
be
charged
before
being
used
for
the
first
time,
please
proceed
as
follows:
-
Rechargeable
battery
pack
are
charged
under
adult
supervision.
-
Insert
the
battery
pack
inside
the
charger,
(pic.5)
then plug
the
charger
to
the
A.C.
socket.
-
Battery
pack
must
be
charged
for
5
hours.
-
After
charging,
plug
out
of
the
socket
and
disconnect
the
charger.(pic.6)
The
specifications
of
the
utilized
unit
must
be
absolutely
observed.
Warning:
in
id
to
obfain
the
battery
with
maximum
performance.
Do
not
charge
the
battery
pack
over
7
hours.
agree vereer ee marmereend Dd Yb AM A cert LA eeN LLN verg III nn
Tri-Band
Selection
ON/OFF
Switch
Transmitter Battery Cover