Need help?Do you have a question about the SilverStone FARA V1 and is the answer not in the manual?
General| Brand | SilverStone |
|---|---|
| Model | FARA V1 |
| Category | Enclosure |
| Language | English |
Mounting for 2.5" SSD, motherboard.
Support for motherboard.
Screws for HDD mounting.
Wire management ties.
Tool for installing standoffs.
Mounting for 2.5" SSD.
Mounting for PSU, Graphics card, 3.5" HDD.
Warranty card.
Step to remove screws.
Step to remove side panels.
Install the Power Supply Unit.
Fasten PSU with screws.
Install the rear I/O shield.
Secure motherboard standoff with wrench.
Install the motherboard.
Fasten with screws.
Remove expansion slot holder and cover.
Secure graphics card and slot holder.
Remove bottom 2 HDD cage screws.
Install 2.5" SSD on top of cage.
Install 3.5" HDD on top of cage.
Install 3.5" HDD.
Select position for HDD cage.
Secure HDD cage.
Secure SSD rubber pads and screws.
Align SSD to mounting hole and secure.
Connect ARGB light strip to PSU.
Connect signal control cable to 2 or 3.
Reinstall side panel and secure screws.
Max cooler height 163mm, 26mm protrusion.
Max length 378mm, width 168mm.
Max PSU depth 206mm.
Top radiator, RAM height, front radiator/fan limits.
Lists fan configurations supported.
Lists radiator sizes supported.
Remove front panel for fans/radiator.
To Next Page