SilverStone SST-ES02-USB User Manual

Product Model No. SST-ES02-USB
Product Description : 2.4GHz wireless computer power and reset remote switch
Package Content
1 x ES02 adapter
1 x 250mm cable
1 x Remote
To install ES02 properly, please follow the steps listed below:
￭ Turn off your computer and unplug the power cord and all cables
￭ Remove your computer’s case cover
￭ Unplug the power cable and reset cable from motherboard
Installation Guide
STEP 1
Carefully install ES02 into the USB 9 pin connector on the motherboard (Figure 1.1), then
connect the “POWER SW” and “RESET SW” to the corresponding pin headers on the
motherboard. (Figure 1.2)
Figure 1.1
USB 9 pin Connector
Figure 1.2
Power / Rest
pin photo

SilverStone SST-ES02-USB Specifications

General

Brand	SilverStone
Model	SST-ES02-USB
Category	Switch
Language	English

Summary

Product Overview and Package Contents

Package Contents

Lists the items included: ES02 adapter, 250mm cable, and remote.

Installation Guide

Connecting the ES02 Adapter

Install ES02 into USB 9 pin connector and connect power and reset switch pins to motherboard headers.

Remote Battery Installation

Remove the screw on the remote to insert the CR 2032 battery and secure it.

Powering On the Computer

Plug in the power cord and press the power button to turn on the computer.

Troubleshooting and FAQs

Computer Not Responding to Power Button

Check LED indicators, battery, and pin connections; consult BIOS/UEFI settings.

Remote and Adapter Not Syncing

Re-sync the remote by holding the adapter's button and pressing a remote button.

Warranty and Compliance Information

Warranty Details

Provides information on the product's limited 1-year warranty and regional support.

FCC Compliance Notice

States compliance with FCC rules and guidelines regarding radio frequency interference.