42C System Operations - 12
on the propeller shafts, rudders, etc., and
should be completed during the spring
launch procedure.
The anodes may require more frequent
replacement, depending on your docking
location and the length of your boating
season. If possible, check the anodes for
excessive corrosion midway through your
boating season. If excessive corrosion is
noted, have your dealer or a competent
technician replace the sacrifi cial zinc an-
odes. Periodically check the wiring con-
nections to make sure they are tight and
free of corrosion. Tighten and clean con-
nections as necessary.
NOTE: Silverton recommends placing
sacrifi cial zinc anodes on the following
components:
• Propeller shafts
• Rudders
• Trim Tabs
IMPORTANT: DO NOT paint any of the
sacrifi cial zinc anodes as it will retard the
fl ow of electric current through them and
render them ineffective.
To Next Page