Sim2 CRYSTAL4-SH - Page 40

CRYSTAL4-SH
User Guide
40
“LCC” gamut. They are selected automatically, depending on the present Display
Mode in use, as described in the table below:
Display Mode
LCC
memory
Natural, HDR, HLG LCC1
Bright, Cinema, Sport, User
LCC2
BrightHDR, BrightHLG, Dynamic
LCC3
Analog Signal
Press the  to enter the menu and then use  or  to select item. This function is
available only for analog input signal (RGB or Component) and permit to adjust the
signal options.
 Automatic
Configure automatically the signal (the frequency and phase items are grayed
out). If automatic is disabled, the frequency and phase items will appear for tuning
and saving the settings.
 Frequency
Change the display data frequency to match the frequency of your computer’s
graphic card. Use this function only if the image appears to flicker vertically.
 Phase
Synchronize the signal timing of the display with the graphic card. If the image
appears to be unstable or flickers, use this function to correct it.
 H. Position
Adjust the horizontal positioning of the image.
 V. Position
Adjust the vertical positioning of the image.
 Exit
Exit from the “Signal” menu.
Auto Adaptive Contrast
Press the  to enter the menu.
Dynamic Contrast enables the projector to automatically optimize the brightness of
the display during dark / light movie scenes to be shown in incredible detail.
SIM2 developed special processing that automatically adapts the parameters of the
projector to the various Blu-ray disks and in particular to the “nits” of the disks,
thus preventing the clipping of the image in the bright part. The result is a rich image