12. ….give power to the unit by master switch.( item 4)
NOTA - With the system in CLEANING MODE the
water pump is the only component in operation to
circulate the cleaning solution in the entire water system
13. Let the unit to remain in the CLEANING MODE for
about 20 minutes and switch OFF the machine.
14. Flush out the cleaning solution from the sump
reservoir then…..
15. ….pour onto the evaporator cavity one or two liters
of clean potable water with cc 2 antibacteria
solution (part number 264000 02) to rinse and
sanitize the molds and the spray system.
ON
PAGE 4/6
To Next Page
Loading...
