X-Press
Operating Instructions
34
5. Servicing and Maintenance
5.10 Maintenance Overview
X-Press Maintenance Overview
After first operation Instructions Interval Note
Check all screw, bolt and plug connections Check they are firmly seated. Tighten / Secure if necessary --- ---
Check wheel studs for tightness Check on delivery and before transporting the machine --- ---
Lubricate machine See overview of lubricating points --- Page 35
During operation
Lubricate machine See overview of lubricating points --- Page 35
Wheel studs Check tightness before transporting the machine 10 hours ---
Disc Angle Adjusters, Disc Pitch, Working Depth Check setting and ensure they are firmly secured 10 hours Page 26
Hydraulic system and components Check seals, signs of crushing/wear, function and condition 10 hours Page 32
Disc Hub Units Check condition, mountings and smooth operation 10 hours Pages 24, 30
Roll bearings Check condition, mountings and smooth operation 10 hours Pages 25, 31
Double Disc roller ring segments Check condition and ensure they are firmly secured 10 hours Pages 25, 31
Safety devices (Parking stands, transport strap) Check condition and function 10 hours ---
After season
Lubricate machine See overview of lubricating points --- Page 35
Toplinks / Bolts Grease any exposed threads --- ---
Entire machine Carry out cleaning and maintenance --- ---
Spray Double Disc roll with oil Use biological oil if possible - cover rubber elements ---
Brakes & Wheel Hubs Service 600 hours Page 31
After 4 years
Hydraulic pipes Replace MRL Anh I EN 1533
To Next Page
Loading...
