Simba X-Press - Preparation for Storage; Operator Support; Maintenance Intervals

35X-Press
Operating Instructions
5.11 Overview of Lubricating Points
Fig. 5.04: DD Roll Grease Points Fig. 5.05: Disc Hub Grease Points
Fig. 5.06: Disc Frame Pitch Adj. Grease Points
Fig. 5.07: Gang Angling Jack Grease Points
Fig. 5.08: Wheel Bearing Grease Points
Fig. 5.09: Drawbar / Axle Cylinder Grease Points
* See page 37, section 5.14 for details
DD Roll Bearings 10 hours 5.04
Disc Hub Bearings 200 hours* 5.05
Disc Pitch Adjuster 50 hours 5.06
Disc Angle Adjustment Jacks 200 hours 5.07
Wheel Bearings 50 hours 5.08
Drawbar & Transport Axle Cylinders 50 hours 5.09
Pivot Points on Wings / Drawbar 50 hours -
X-Press lubrication points Interval Diag. No.
5. Servicing and Maintenance