Sime Brava Slim Series - Safety, Compliance, and Symbols; Compliance Directives; Symbol Explanations

2
EN
SAFETY WARNINGS AND REGULATIONS
For the "SAFETY WARNINGS AND REGULATIONS" please refer to the information provided in the relevant section of the "INSTAL-
LATION AND MAINTENANCE MANUAL".
Dear Cust
omer,
Thank you for purchasing a
Sime Brava Slim boiler, a new-generation low-temperature modulating device possessing technical and
performance characteristics capable of satisfying your space heating and instant domestic hot water requirements with the utmost
safety and with limited running costs.
COMPLIANCE
Our company declares that Brava Slim boilers comply with the
following directives:
– Gas Appliances EU Regulation 2016/426
– Boiler Efficiency Directive 92/42/EEC
– Low Voltage Directive 2014/35/EU
– Electromagnetic Compatibility Directive 2014/30/EU
SYMBOLS
a
WARNING
To indicate actions which, if not carried out correctly,
can result in injury of a general nature or may damage
or cause the appliance to malfunction; these actions
therefore require particular caution and adequate
preparation.
f
ELECTRICAL HAZARD
To indicate actions which, if not carried out correct-
ly, could lead to injury of an electrical nature; these
actions theref
ore require particular caution and ade-
quate preparation.
d
IT IS FORBIDDEN
To indicate actions which MUST NOT BE carried out.
m
CAUTION
To indicate particularly important and useful informa-
tion.
TABLE OF CONTENTS
m
CAUTION
Fonderie SIME S.p.A. reserves the right
to make improvements to its products
at any time without prior notice, without
compromising their essential charac-
teristics. The graphic illustrations and/
or images in this document may show
optional accessories that vary according
to the country in which the appliance is
used.
1 COmmiSSiONiNG 3
1.1 Preliminary checks ..............................3
1.2 Ignition ........................................3
1.3 Adjusting the heating temperature .................3
1.4 Adjusting the domestic hot water temperature .......3
1.5 Fault / malfunction codes .........................4
1.5.1 Maintenance request ................... 4
2 SHUTDOWN 4
2.1 Temporary shutdown.............................4
2.2 Shutting down for long periods ....................5
3 maiNTENaNCE 5
3.1 Adjustments....................................5
3.2 External cleaning................................5
3.2.1 Cleaning the cladding................... 5
4 DiSPOSal 5
4.1 Disposal of the equipment (European Directive
2012/19/EU) ....................................5