Need help?Do you have a question about the Sime Ecomfort and is the answer not in the manual?
General| Fuel Type | Natural Gas |
|---|---|
| Installation Type | Wall Mounted |
| Flue Type | Condensing |
| Type | Condensing |
| Category | Boiler |
Overview of the Sime ECOMFORT boiler's features and operation modes.
Explains how the boiler senses water flow and initiates burner ignition for hot water.
Step-by-step guide for lighting the appliance, including initial checks and selector switch settings.
Instructions for turning off the appliance for short and long periods, including frost protection.
Specifies the required air gaps around the appliance for ventilation and servicing.
Recommends regular checks and servicing for efficient operation, emphasizing legal requirements.
Explains the meaning of LED indicators for fault detection and troubleshooting.
Explains the function of the facia panel gauge for system pressure monitoring.
Details the required mains plug type, fuse rating, and earthing for the appliance.
Notes on ventilation requirements for the appliance, especially when installed in a cabinet.
Instructions on how to clean the appliance outer casing using a damp cloth and mild detergent.
Essential instructions for safe and economical operation, including flue terminal obstruction and gas leak warnings.
Steps for commissioning the receiver and transmitter for the analogic RF time programmer.
Guide for setting up and using the analogic RF time programmer.
Instructions for setting the correct time on the analogic RF time programmer.
How to program heating start and stop times using tappets on the time programmer.
Guide to setting desired room temperatures using the maximum and minimum dials.
Explanation of the manual switch function for timed, continuous, or minimum heating.
Steps for commissioning the receiver and transmitter for the digital RF time programmer.
Guide for setting up and using the digital RF time programmer.
Instructions for setting the current time on the digital RF time programmer.
Instructions for selecting the required maximum room temperature on the digital programmer.
Instructions for selecting the required minimum room temperature on the digital programmer.
Guide to selecting pre-set heating programmes (P1-P4) or daily settings (Pd).
To Next Page