23
+
Picture 2
Picture 3
Mount your glass by placing it on the mounting rack below by placing
one side, then placing on the other side and x it as shown in Figure 2.
Then place the glass stopper on the left side of the lower canal with
the tabs in the back.
Slide the glass on the bottom channel to the left (Fig-
ure 3). Do the same with the channel gap in the right side so
that the tabs of the glass stopper pass through the channel.
Do the same by repeating the same process when installing the upper
glass.
NOTE: The glass stoppers will be placed in the prole channel on the
front side of the cooler in the at cooler and on the prole channel on
the rear side of the cooler in the inclined cooler.
CASTOR MOUNTING INSTRUCTIONS
To Next Page
Loading...
