19
Camera won’t power up
Make sure that you have installed all 4 batteries in the battery 1.
compartment. Simmons recommends using 4 Energizer®
Alkaline or Lithium batteries in this Trail Cam.
Make sure that the batteries are installed correctly, observing 2.
proper polarity. Always place the negative (at) end of each
battery in contact with the spring side of its slot inside the
camera.
Still Photo and/or Video Quality Problems
1. Night photos or videos appear too dark
a. Try using a set of new batteries. The ash will stop operating
near the end of the battery life.
b. You will get the best results when the subject is within the ideal
ash range, no farther than 30’ (9m) from the camera. Subjects
may appear too dark at greater distances.
c. (119233C only) Please note that when the shot mode is set to
“3P”, or with very short trigger interval settings, some images
may appear darker than others due to the quick response and
rapid retriggering of the camera, allowing less time for the ash
to fully recharge before ring again.
2. Daytime photos or videos appear too dark
a. Make sure that the camera is not aimed at the sun or other
light sources during the day, as this may cause the auto exposure
to produce darker results.
3. Night photos or videos appear too bright
a. You will get the best results when the subject is within the ideal
ash range, no closer than 10’ (3m) from the camera. Subjects
may appear too light at closer distances.
4. Daytime photos or videos appear too bright
a. Make sure that the camera is not aimed at the sun or other
light sources during the day.
Troubleshooting / FAQ
To Next Page
Loading...
