Simoco SRM9000 - Adjustment and Alignment

SRM9000 ALIGNMENT TNM-M-E-0019 Issue 1
Page 11 of 13
Tx Power
1.
Select Tx Power/Mod page.
2.
Select Channel 0.
3.
Select the 1W power level.
4.
Press the PTT button.
5.
Adjust the Tx Final Value slider for a power output of 1W.
6. Repeat step 5 for the remaining 3 Channels (1, 2, & 3).
7.
Select the 5W power level.
8.
Adjust the Tx Final Value slider for a power output of 5W.
9. Repeat step 8 for the remaining 3 Channels (2, 1& 0).
10.
Select the 25W power level.
11.
Adjust the Tx Final Value slider for a power output of 25W.
Note that the supply current is less than 6.5A.
12. Repeat step 11 for the remaining 3 Channels (1, 2, & 3).
13 Rev 9C+ only, press “Calibrate TX PA Current” button to automatically set the maximum current limit.
Note: This feature is not available on earlier radios and therefore will not be displayed.
14
Release the PTT button.