DRAFT D
TNM-M-E-0001 Page 33
5.
Select the Rx Front End Page
6.
Select Channel 0
7. Set the Signal Generator to the Channel 0 carrier frequency, with a 1000Hz modulation
signal, a deviation of ±1.5 kHz and a RF level of -90dBm.
The RSSI barchart display should now be (typically) well above a reading of 20 - if so,
jump to step 9.
8. If the RSSI is not visible or is very low, Manual Tuning may be required. To do this, adjust
the four Filter sliders (1-4) in combination for the maximum RSSI reading or for the best
sinad reading. Proceed to step 9 when an RSSI of better than 20 is achieved.
Note: For optimum results, the sliders should be adjusted to be approximately in line.
9.
Select Auto Align.
The front end will be tuned automatically.
1
0.
Verify that the receiver sensitivity is better than -117.5dBm for 12dB sinad. (Sensitivity is
typically -120dBm).
1
1.
Repeat Steps 7 to 10 for the remaining 3 Channels (1, 2, & 3).
To Next Page
Loading...
