Simon 3 - Home Control Planning; System Access Codes; Option Settings

35
Appendix B: System Configuration
System Access Codes
The factory default settings are 4-digit access codes, but the
default codes will change whenever Option 54 (Access Code
Length) is reset. The default for each access code length is listed.
Option Settings
Home Control Planning Table*
Module Activated by Time Activated
Unit # Type Location Sensor Entry/Exit Start Time Stop Time
Example Lamp Hall lamp Motion Yes 8 p.m. 10:30 p.m.
1
2
3
4
5
6
7
8
System Access Codes
Type Default
a
Installer
Settings
Utility Access Code 1 654321,
54321,
4321, or
321
Utility Access Code 2 654321,
54321,
4321, or
321
Master Access Code 123456,
12345,
1234, or
123
Access Code 1 None
Access Code 2 None
Access Code 3 None
Access Code 4 None
Access Code 5 None
Panic Code None
a.