Simon XTi System Manual
http://alpha.adt.com/help/266[11/14/2018 8:05:18 PM]
(Spoken phrases on the speaker and key press sounds from the speaker heard while controlling the
system.) This option determines whether the panel speaks status messages and arming level changes. To
program panel voice:
1. From the Programming screen, press [SIREN OPTIONS].
2. To turn on panel voice, press the box. To turn off, press the checked box.
3. Press [CLOSE] repeatedly to exit menus.
Panel Piezo Alarms
(Loud alarms on the siren). This option determines whether the panel sounds alarm beeps. To program
panel piezo alarm:
1. From the Programming screen, press [SIREN OPTIONS].
2. To turn on panel piezo alarms, press the box. To turn off, press the checked box.
3. Press [CLOSE] repeatedly to exit menus.
Trouble Conditions
Your security system is able to automatically test itself for power failures, low batteries, nonworking
sensors, and communication troubles with the central monitoring station. When your security system
detects a trouble condition, six rapid beeps will sound every minute for four hours until the trouble
condition is corrected.
To silence trouble beeps, press [STATUS] or arm/disarm the system.
For a complete list of Trouble Conditions, please refer to the Simon XT Troubleshooting
page
User Access Codes
Access Code Programming
To enter programming mode:
Note: Programming mode can only be entered if the system is disarmed.
1. Enter the Status & Settings menu.
2. Scroll until Programming is listed, press the Enter icon.
3. Enter your [master code], and then press [OK].
Note: You have four seconds between number presses to enter the code or you will be returned to the
home screen.
To Next Page
Loading...
Need help?
General