Fig. 20
Fig. 19
Fig. 18
44
UK
4 Connect the other end of the pipe to the water
mains.
5 The machine is fitted with a pressure reducing
valve, pre-set to approx. 1.1 bar and accessed by
opening the hatch in the top of the machine.
To change the set pressure, lift the knob of the
pressure reducing valve and turn it clockwise to
increase the pressure or counter-clockwise to
reduce it. Lower the tap back into place when
finished.
NOTE: The maximum outlet pressure from the pres-
sure reducing valve MUST NOT exceed 1.5
bars.
3 Connect one end of the pipe to the 3/4” inlet on the
back of the machine.
The water hardness must be less then 4° - 6° fr
(french degree).
The chlorine contents is max 100 mg per litre
(0.00000361 lb/cu in).
The machine must be installed according
to the local standards in force with regard
to plumbing systems. For this reason, the
plumbing connections must be carried
out by a qualified technician.
1 Remove the cap to access the granulated coffee
bean container.
WARNING
4.3 FILLING THE COFFEE
CONTAINER
2 Don’t fill to the brim but pour just enough toasted
coffee beans into the coffee bean holder to
ensure correct closure of the unit.
Otherwise the conditions of guarantee of the
machine will expire.
Pour ONLY toasted coffee beans into the coffee
bean holder. any other kind of coffee, for example
ground coffee, will damage the coffee grinder.
Don’t insert caramelized, sugar coated, or simi-
larly coated coffee beans, or instant coffee or
other sugary beverages because they will harm
the appliance.
4.2 MACHINE
INSTALLATION
(VERSION FOR DIRECT
CONNECTION)
Once the machine has been withdrawn from the
packaging, carry out the following instructions:
1 Position the unit on a horizontal surface.
2 Remove the pipe with 3/4” coupling from the
hatch in the top of the machine.
The water hardness must be less then 4° - 6° fr
(french degree). The chlorine contents is max
100 mg per litre (0.00000361 lb/cu in).
Otherwise the conditions of guarantee of the
machine will expire.
WARNING
ATTENZIONE
To Next Page
Loading...
