56
UK
13. GROUNDS NUMBER
Press the ENTER key to access the submenu.
This allows you to program the GROUNDS
NUMBER. When the number has been
reached, a message will be displayed instruct-
ing you to empty the coffee grounds drawer
and the machine will stop working to allow the
procedure to be done safely.
The arrow keys increase/decrease the grounds
number to proceed to the emptying of the coffee
grounds drawer. Press the RESET key to exit the
submenu and go back to the main menu and to con-
firm the grounds number programmed.
The ENTER key is disabled.
14. MILK CLEAN WARN. H
Press the ENTER key to access the submenu.
This allows you to program after how many
hours, following the last milk delivery, the milk
foamer cleaning warning will be displayed.
The arrow keys increase/decrease the amount
of hours for the display of the milk foamer cleaning
warning message.
Press the RESET key to exit the submenu and go
back to the main menu and to confirm the number of
hours programmed. The ENTER key is disabled.
15. CLEAN WARNING
Press the ENTER key to access the submenu.
This allows you to program the number of
cycles after which the group clean warning will
be displayed.
The arrow keys increase/decrease the amount
of cycles for the display of the group clean warning
message. Press the RESET key to exit the submenu
and go back to the main menu and to confirm the
number of cycles programmed.
The ENTER key is disabled.
16. SHUT DOWNCLEAN
Press the ENTER key to access the submenu.
This programmes a cleaning cycle for the dis-
penser group when the machine is switched off.
Set to YES to enable this function.
If the function is enabled, 100 cm3 (6.1024 cu in)
of water will be dispensed
Press the keys to enable (YES) / deactivate
(NO) cleaning at the end of service.
17. GROUP SETTING
Press the ENTER key to access the submenu.
This allows you to program the group reposi-
tioning.
The arrow keys increase/decrease the riascent
of the motor.
Press the RESET key to exit the submenu and go back
to the main menu and to confirm the programming.
The ENTER key is disabled.
18. GRINDER SETTING
Press the ENTER key to access the submenu.
This allow you to program the choice of
increasing grinding times by 0.1 seconds every
250-1000 deliveries.
By setting the program at 0, the function is
disabled
The arrow keys increase/decrease the number
of deliveries, after which there will be an increase in
grinding time.
The available values are 0, 250,500, 750, 1000.
Press the RESET key to exit the submenu and go
back to the main menu and to confirm the number of
deliveries programmed.
The ENTER key is disabled
19. COFFEE TEMPERAT.
Press the ENTER key to access the submenu.
This allow you to program the temperature of
the coffee heater.
The arrow keys increase/decrease the tem-
perature of the coffee heater.
La temperatura massima impostabile è 105°C
(221°F).
Press the RESET key to exit the submenu and go
back to the main menu and to confirm the tempera-
ture programmed.
The ENTER key is disabled.
20. STEAM TEMPERAT.
Press the ENTER key to access the submenu.
This allow you to program the temperature of
the steam boiler.
The arrow keys increase/decrease the tem-
perature of the steam boiler.
To Next Page
Loading...
