Simonelli MICROBAR - Coffee Holder and Coffee Delivery Unit Cleaning

Fig. 46
Fig. 47
Fig. 48
1
2
Fig. 49
Fig. 50
UK
63
• Use a small brush to clean any deposits or coffee
residues off the piston and the delivery unit site
or any other areas soiled with coffee.
9.9 CLEANING THE
GASKET
NOTA: Follow the instructions applied on the label on
the inside of the front door too.
• Set the machine to the “O” energy level.
9.10 CLEANING THE MILK
FOAMER
• Insert the key in the lock.
• Turn the Front panel opening key counter-clock
-
wise.
• Open the Front panel.
IMPORTANT: Proceed with caution
• Disconnect all the tubes attached to it.
• Disassemble the milk foamer and wash it care
-
fully.
NOTE: If the pause between one cappuccino and
another is over one hour long, it is advisable
to wash the milk foamer by fishing the milk
suction tube in hot water rather than in milk.
• To reassemble proceed inversely, attaching the
milk foamer tubes properly.
NOTE: To make the reassembling procedure easier,
an explanatory label has been attached to
the front door.
• Clean the drop collector (see paragraph THE
DROP COLLECTING TRAY GRID).
• Extract the whole delivery unit including the milk
foamer, pulling it towards you.
• Extract the milk foamer from the delivery group by
sliding it upwards.