To Next PageTo Next Page
Need help?Do you have a question about the Simoniz 39-9027-4 and is the answer not in the manual?
Essential safety practice requiring approved safety goggles (ANSI Z87.1) to prevent eye injury.
Guidelines for maintaining a clean, well-lit, and hazard-free workspace to prevent accidents.
Covers safe use of double-insulated tools, avoiding grounded surfaces, and protection from wet conditions.
Proper selection and use of extension cords based on gauge, length, and tool ampere rating.
Emphasizes staying alert, dressing properly, avoiding accidental starting, and maintaining balance.
Proper techniques for using, securing, and maintaining the tool for safe operation.
Guidelines for proper servicing, using only identical replacement parts, and avoiding unauthorized repairs.
Rules for safe operation, including pad contact, two-hand control, submersion, and ventilation.
Lists recommended accessories and warns against using improper or unread accessories.
Guidance on carefully unpacking and comparing components against a chart, with a warning for missing parts.
Steps to clean and dry the vehicle or boat surface before polishing or waxing.
Instructions for correctly placing the wax applicator bonnet onto the foam pad.
Method for applying paste wax to the applicator bonnet, not directly to the car.
Method for applying liquid wax to the applicator bonnet, with quantity guidance.
Guidance on applying wax evenly to the surface to be polished, avoiding excessive pressure.
Instructions on how to operate the ON/OFF switch for the tool.
Details on applying wax using straight lines, side-to-side, or back-and-forth motions.
Instructions for correctly placing the terry cloth polishing bonnet onto the foam pad.
Process for removing dried wax using long, sweeping strokes in a criss-cross pattern.
Recommendations for regular car washing, cleaning, and protection of paint finish.
Instructions for washing bonnets, disposing of wax applicators, and storing the foam pad.
Rules against using abrasive compounds, applying too much wax, and cleaning the tool.
Step-by-step guide for removing and replacing the pad assembly using specific tools.
General
