Compact Reader 3078, can be connected as a wireless element. If the
system is extended at a later stage, cylinders can be networked without
wiring and managed in an online interconnected system.
The locking cylinders are provided with two different firmware generations
– G1 and G2. G2 features a more efficient communication protocol than G1.
It will allow you to create larger, more efficient locking systems.
Authorisations are written both on the locking cylinder and the transponder,
thus delivering greater flexibility for programming. A G2 system can also
form a virtual network, i.e. authorisations and blocking lists are written on
the transponder and transmitted into the locking system. Refer to the G2
manual for more details.
4.2 Locking cylinder design
1. Inside thumb-turn
2. Batteries/electronics
3. Actuator
4. Drilling protection
5. Outer thumb-turn
4.3 Half cylinder design
1. Actuator
2. Electronics
3. Batteries
4. Thumb-turn
Digital Locking Cylinder 3061
(Manual)
4. General
15 / 54
To Next Page
Loading...