SimonsVoss 3061 FD - Installing Swiss Round

This generally also applies when installing the cylinder in a key switch, for
example.
6.3.5 Installing Swiss Round
Both cylinders and a fitting need to be removed from doors when installing
a Swiss round cylinder.
The inside thumb-turn is removed and re-fitted in the same way as Half
Cylinder DK / MR.
The outside knob is removed and re-fitted in the same way as the outside
knob on a VdS cylinder.
1. Disassemble inside thumb-turn and outside thumb-turn. Remove a fit-
ting from the door.
2. Push cylinder into the profile and fasten with the fastening screw.
3. Fit inside thumb-turn and outside thumb-turn. Mount fitting again.
Digital Locking Cylinder 3061
(Manual)
6. Installation instructions
33 / 54