Simplex 2084-9002 - User Manual

Features
Firefighter telephones provide direct
communications with the Firefighter Telephone
Control’s master phone:
• When remote phones call the master, a call tone is
provided to verify that the request is in process (exact
performance may vary depending on master phone
equipment)
• Two-wire telephone circuits are supervised and
power-limited
• Compatible with 4100U Series and legacy 4100/4120
Series Simplex® Firefighter Telephone Controls
Phone assemblies are available for:
• Surface or flush mounting, (NOTE: backbox is ordered
separately)
• Or as separate phone sets for plugging into dedicated
remote phone jack stations
Available options:
• Break-rod door latch allows access during emergencies
• Armored cable models to minimize vandalism (voice
and ear caps are sealed with adhesive)
• Push-to-talk (PTT) phones provide input control at the
remote phone
• Magnetic latch models with “Fire Warden Station”
marking and LED call indicator
• Additional options are listed on page 3
Available Accessories:
• Replacement break-rod
UL Listed to Standard 864
Description
Firefighter telephone systems provide two-way
communications for facilities where radio communications
may not be available or are unreliable. They are typically
used during active firefighting conditions, during a fire alarm
investigation, or during fire alarm system inspection and test.
Operation requires a dedicated two-wire circuit, typically
using twisted, shielded pair wiring (TSP) to minimize
electrical noise pickup from adjacent wiring. Depending on
the master control, up to 6 remote phones and the master can
be in simultaneous use. Additional information can be found
in Installation Instructions 579-226 and on data sheet
S4100-0034 which describes 4100U Master phone control
operation.
* ULC listing is applicable to standard remote pluggable phone and phone jack station, refer
to page 3 for agency status per model. This product has been approved by the California
State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety
Code. See CSFM Listing 6912-0026:054 for allowable values and/or conditions concerning
material presented in this document. It is subject to re-examination, revision, and possible
cancellation. Accepted for use – City of New York Department of Buildings – MEA35-93E.
Additional listings may be applicable; contact your local Simplex product supplier for the
latest status. Listings and approvals under Simplex Time Recorder Co. are the property of
Tyco Safety Products Westminster.
FIRE
PHONE
EMERGENCY
FIRE
PHONE
EMERGENCY
2084-9001 2084-9023
Remote Phone Jack Stations
LOCAL
FIRE EMERGENCY
PHONE
Door and Trim, Surface Mount
LOCAL
FIRE EMERGENCY
PHONE
PULL FOR
EMERGENCY
ONLY
Door and Trim, Flush Mount
with Pull Handle and Break-Rod
Life Alarm
®
Fire Alarm Systems
UL, ULC, CSFM Listed; FM Approved; Remote Emergency Telephone Equipment
MEA (NYC) Acceptance* 2084 Series Firefighter Telephones
S2084-0001-8 5/2006

Summary

Features of Simplex Firefighter Telephones

Direct Communication Capabilities

Describes direct communication with master phone and call tone verification.

Phone Assembly Mounting Options

Lists mounting options like surface/flush and separate phone sets for jack stations.

Optional Features for Phone Assemblies

Details options like break-rod latch, armored cable, and push-to-talk.

Available Accessories

Lists optional accessories, such as replacement break-rods.

Description of Firefighter Telephone Systems

System Operation Requirements

Explains the need for a dedicated two-wire circuit for system operation.

Remote Phone Jacks

Phone Jack Mounting Details

Provides specifications for mounting phone jacks and wiring requirements.

Remote Phones, Cabinet Mounted

Cabinet Mounted Phone General Information

Overview of cabinet-mounted phones, including door and trim options.

Break-Rod Door Option

Details the break-rod door option for emergency access.

Phone Handset Options

Describes armored cable phones and push-to-talk functionality.

Remote Fire Warden Station

Explains the Fire Warden Station variant with magnetic latch and LED.

Pluggable Phones

2084-9014 Red Pluggable Phone

Details the 2084-9014 pluggable phone construction and cord length.

2084-9024 Push-to-Talk Pluggable Phone

Describes the 2084-9024 pluggable phone with a push-to-talk switch.

Firefighter Phone Backbox and Assemblies

Firefighter Phone Backbox Specifications

Details the dimensions and requirements for the 2975-9053 backbox.

Phone Assemblies for Backbox Mounting

Lists phone assemblies for backbox mounting with features and listings.

Pluggable Phones and Jack Stations

Lists pluggable phones, jack stations, and their agency listings.

Firefighter Phones Accessories List

Lists accessories like break-rods and EOL resistor harnesses.

Door Trim Dimension Reference

Surface Mount Assembly Dimensions

Provides dimensional reference for surface mount assemblies.

Flush Mount Assembly Dimensions

Provides dimensional reference for flush mount assemblies.

Simplex 2084-9002 Specifications

General

Brand	Simplex
Model	2084-9002
Category	Emergency Phone
Language	English