.
If you wish to temporarily connect the Centronics 150 printer to the ADDS CRT/keyboard AUX port for service
printouts, etc., do so using Figure 19.
NOTES
does not seem to function, you can enable it by holding down the
key. To disable the port once enabled by CTRL-R, hold down the
(CTRL( key and press the m key.
2. Do not use the ADDS CRT/keyboard AUX port for permanent connections because the AUX port must be
enabled by a CTRL-R anytime the ADDS CRT/keyboard is powered-up.
ADDS AUX PORT
(6) ;::;:f: 577 s’E
(2) 166-075
(6)
474-228 (18-22 AWG)
(1)
166-078 SHELL
(1)
(3)
(3)
(1)
PARTS REQ’D
166-075
474-169 (28-24 AWG)
OR
474-228 (18-22 AWG)
166-078 SHELL
“handshake” line to TB3-2 on the
3
7 11
2120
BMUX.
TO CENTRONICS
150
PRINTER
Note: Unless running the printer at
300 baud, you must connect this
Centronics Printer-to-ADDS Aux Port
Connections
FIGURE 19
THE CENTRONICS H80
The Centronics H80 (Figure 20) is a printer that provides a hard copy of 2120 status reports.
The Centronics H80 Printer
FIGURE 20
Note: The Centronics H80 printer replaced the Centronics 150 printer.
17
To Next Page
Loading...
