THE CENTRONICS HPC-80
The Centronics HPC-80 (same external view as Figure 20) is a printer which provides a hard copy of 2120 status
reports.
Note: The Centronics HPC-80 printer replaced the Centronics H80 printer.
CENTRONICS HPC-80 JUMPER PLACEMENTS AND SWITCH SETTINGS
See “CENTRONICS H80 OPTION SWITCHES” section for how to remove the HPC-80 cover.
See Figure 26 to locate jumpers and DIP switches.
Retain factory jumper placements of Jl, 2, 3, 5 & 6 in “A” position and J4 in “B” position.
“A” POSITION
“8” POSITION
JUMPER
POSITIONS
Location of HPC-80 Jumpers and DIP Switches
FIGURE 26
The switches are set as indicated below. Factory settings are indicated in bold
PROTOCOL
Ready/Busy = switch 1 OFF
XONiXOFF = switch 1 ON
PARITY SWITCH 2
SWITCH 3
EVEN ON
OFF
ODD
OFF
ON
NONE OFF
OFF
DATA WORD LENGTH
8-bit data = switch 4 ON
7-bit data = switch 4 OFF
STOP BIT LENGTH
1 bit = switch 5 OFF
2 bits = switch 5 ON
21
To Next Page
Loading...
