Simplex Digital Lock
S
implex 3000 Drive Assembly - Instructions
First Choice for Locking Solutions
012 0 2 676262 01202 680101 alpro@iecltd.co.uk www.alpro.co.uk
T F E W
alpro
®
TABLE OF CONTENTS
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . .1
Tools Required for Installation . . . . . . . . . . . . . . . . .1
A. Hardware Disassembly . . . . . . . . . . . . . . . . . . . .1
Cam Plug Handing . . . . . . . . . . . . . . . . . . . . . . . .2
B. Stile Preparation for Combination Side of Door 2
C. Stile Preparation of Trim Plate Side of Door . . . .3
D. Drill Lock and Trim Plate Mounting Holes . . . . .3
E. Hardware Assembly . . . . . . . . . . . . . . . . . . . . . . .3
Package Contents:
1 x drive assembly
1 x cam plug
1 x cardboard template
1 x cam plug cover (
31
/32" backset only)
2 x mounting screws 10-24 thd x 1
1
/2"
2 x threaded sex nuts
2 x mounting bushings
Tools Required For Installation
• tape
• electric drill (variable speed recommended)
• small flat head screwdriver
• medium flat head screwdriver
• large phillips head screwdriver
• center punch
• (
31
/32") drill bit
• (
3
/8") drill bit
• (
7
/8") hole saw
• (
1
/8") drill bit
• (
1
/4") drill bit
• hammer
• deburring tool
• safety goggles
Warnings & Cautions
Important: Carefully inspect windows, doorframe,
door, etc. to ensure that the recommended
procedures will not cause any damage. Warranty
does not cover damages caused by installation.
Caution: Wear safety glasses when preparing door.
Read all instructions before starting installation
Installation
A HARDWARE DISASSEMBLY
A-1 Remove face plate from edge of door exposing
the cylinder set screws (See Figure 1).
A-2 Loosen the cylinder set screw (securing key
cylinder to latch) and remove the cylinder from
the dead latch assembly (See Figure 1).
A-3 With the exception of the dead latch assembly,
remove all other hardware from door: knob,
handle, etc (See Figure 1).
To Next Page
Need help?
General
