Simplex LP1000 - User Manual

Changing the Code/Combination
Simplex LP1000/8100
LP1000/8100 Series FAQ
Changing the Code/Combination
Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may
be a ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting
procedures outlined at bottom of this document for a zero code symptom/solution.
For your security the combination must be changed when the lock is in-
stalled. The door must be open.
On models with passage feature, make sure the passage feature is disengaged:
turn knob or key should be in vertical position.
1. Remove the tamper proof allen screw (A) using (B) tamper proof allen
wrench supplied with lock (see gure 1).
2. Turn the outside lever once to the stop position then release
(see gure 3).
3. Enter the existing combination. On new installations, enter the factory-
set combination: depress buttons 2 and 4 simultaneously (release) , then
depress button 3 (release). You should feel a click as each button
is depressed.
4. Insert the pick tool (C) as shown in gure 2. Gently depress pick tool in
hole (a slight click should be felt), then remove the pick tool.
5. Turn the outside lever once to the stop position then release
(see gure 3).
6. Select a new combination, write it down, then enter the new
combination—depress buttons carefully (a slight click should be felt as
each button is depressed)
Note: You can use one button or all ve for a combination, but each button can
only be used once. You can press two or more buttons simultaneously as a step
in the combination.
7. Turn the outside lever once, all the way until it stops, hold in position
and make sure the latch is retracted fully. Release the lever. Turn the
lever again to the stop position. At this point, the latch should not
retract unless you enter the new combination (see gure 3).

Simplex LP1000 Specifications

General

Brand	Simplex
Model	LP1000
Category	Door locks
Language	English

Summary

Changing the Code;Combination Simplex LP1000;8100

Remove Tamper-Proof Screw

Remove the tamper proof allen screw using the supplied tamper proof allen wrench.

Turn Outside Lever to Stop Position

Turn the outside lever once to the stop position and then release it.

Enter Existing Combination

Enter the existing combination or the factory-set combination for new installations.

Insert and Remove Pick Tool

Gently insert the pick tool into the hole and remove it after feeling a slight click.

Turn Outside Lever Again

Turn the outside lever once to the stop position and then release it.

Select and Enter New Combination

Select a new combination, write it down, and enter it carefully.

Test New Combination

Turn the outside lever fully, retract the latch, and test that it does not retract without the new combination.

Re-secure Tamper-Proof Screw

Re-secure the anti-tamper screw back into the housing.

Troubleshooting Lock Issue

Lever Retracts Without Button Press

Symptom: Lever retracts latch without button press. Cause: Lock is in zero combination.

Troubleshooting Zero Combination Solution

Solution: Follow combination change procedure, omitting step 3 (entering existing combination).