CAM PLUG HANDLING
A-4 Determine the required handing of cam disc on cam
plug (See Figure 2). Looking at the edge of the
door, determine on which side the lock is to be
installed.
If the cam disc handing needs to be changed,
proceed with steps A to D.
If not, proceed to Section B-1.
A. Remove the retainer clip from the pivot pin.
B. Pull the cam pivot pin out of the disc.
Note: Do not remove the driver piece.
C. Turn the cam over and push the cam pivot pin
through the cam and into the disc.
D. Reinstall the retainer clip onto the cam pivot pin.
B STILE PREPARATION FOR COMBINATION
SIDE OF DOOR
B-1 Install cam plug to the dead latch. Snug tighten the
cylinder set screw. See Section D-1 for final screw
adjustment (See Figure 1).
B-2 Position the cardboard template (locate on cam plug
pins) as shown (See Figure 3). Align template such
that it is parallel to the stile of the door.
Note: It may be necessary to further loosen the
cylinder set screw referred to in Section A-2
allowing movement of the template. Secure
template to the stile using tape.
B-3 Center punch templates holes marked A, B and C
(See Figure 3).
B-4 Carefully remove cardboard template (to be used
again in Section C-1). Drill pilot holes marked A, B
and C using a .094 (
3
⁄32") diameter drill bit (See
Figure 4).
Note: Drill through lock side of door only.
(Wear safety goggles when drilling).
To Next Page
Loading...