15
During system startup, you will see this prompt:
Press del key to enter Setup
Press [DELETE] while this message is on the screen to configure CMOS Setup.
Note: You will only have a short amount of time to do this. If you miss this message
and hit the delete key too late, press [CTRL + ALT + DELETE] to restart the
computer and try again.
Note: Make changes to the setup screens by using the arrow keys and the page up
and page down keys. The screens themselves provide instructions for altering
their content.
1. Highlight and select “Auto Detect Hard Disks” from the list on the main setup screen.
2. Make sure that the hard drive has been recognized and has the correct settings.
Note: If the Pri Master is listed as Type “Not Installed” then you may have improperly
connected the hard drive. Check the adapter and cable connections at the hard
drive and CPU board.
AMIBIOS SETUP – STANDARD CMOS SETUP
© 1996 American Megatrends, Inc. All Rights Reserved
Date (mm/dd/yyyy) : Sat, May 27. 1999 Base Memory: 640 KB
Time (hh/mm/ss) : 01:58:01 Extd Memory: 15 MB
Floppy Drive A : 1.44 MB 3½
Floppy Drive B : Not Installed
LBA Blk PIO 32Bit
Type Size Cyln Head Wpcom Sec Mode Mode Mode Mode
Pri Master : User 6194 13424 15 0 63 On On 4 Off
Pri Slave : Not Installed
Sec Master : Not Installed
Sec Slave : Not Installed
Boot Sector Virus Protection Disabled
Month: Jan -- Dec ESC:Exit : Sel
Day : 01 -- 31 PgUp/PgDn: Modify
Year : 1901 – 2099 F2/F3: Color
Figure 12. Auto Detect Hard Disks Screen
3. Press [ESC] to return to the main setup screen.
Continued on next page
Configuring CMOS Setup
Enter Main Setup
Screen
Check Settings on
the Auto Detect Hard
Drive Screen
To Next Page
Loading...
