Simplex 4604-9201 - Page 14

Installation, Confinued
Setting the Annunciator
Address and Baud Rate
:sw3
I
. -
0
I
.
ADDRESS
SW1
0
I:::::I
199QQ9Ql
I
RESET RESET
DOWNLOAD
+24 24~
+COM -CONI SHLD
Set the annunciator’s address and baud rate using DIP Switch SW3 (Figure 6).
(Refer to Appendix A for the Annunciator Address Chart.)
CONTRAST ADJUST
BOlTOM OF ELECTRONICS ASSEMBLY
(SHOWN SET FOR ADRESS
BAUd RATE
6 AND 9600 BAUD)
Figure 6. Setting the Annunciator’s Address and Baud Rate
Continued on next pag-
14
firealarmresources.com