Installation,
Continued
Mounting the Electronics
Assembly
Mount the electronics assembly in the following manner.
1. Place the electronics assembly on the back box. (See Figure 5.)
CAUTION:
Make certain that you do not pinch any wiring behind the electronics
assembly when mounting as damage may occur
to the equipment.
2. Align the four holes on the back box with the four holes on the
electronics assembly.
3.
Insert the four screws that you removed earlier into the holes in the back box.
4. Using the information in Table 8, securely tighten these screws.
MOUNTING SCREWS
Figure 5. Mounting the Electronics Assembly
Continued on next page
13
To Next Page
