Simplex IDNet 4009-9301 - Mounting Procedure

12
Note: T
he following pages provide a detailed description of the installation.
If you experience problems that cannot be resolved, call your local
Simplex Branch Office.
Use the following procedure when mounting a 4009 IDNet.
CAUTION: Read all instructions carefully before cutting conduit/service
entrances and installing back box. Failure to comply with all
installation requirements may result in a violation of UL or
FCC regulations.
1. Carefully open the shipping container.
2.
Remove the 4009 IDNet from the shipping container and lay the unit on
a
f
lat surf
ace.
3.
Unlock and open the panel door. Remove the electronic card cage assembly
and store it in a safe dry area. Disconnect the AC wiring harness from th
e
card cag
e before removing it from the box
.
4
. Determine the amount and proper location of conduit/service entrances (s
ee
Fig
ure 6). Make all appropriate entrances into the back box
.
P
ower-Limited and Non-Power Limited wiring must enter through separate
conduit/service entrances. AC power entrance into the back box
is
recom
mended at the bottom right side of the back box
.
Maximum intrusion into back box for conduit is ½ -inch.
Figure 6. Installing the 4009 IDNet Back Box
Continued on next page
System Installation, Continued
Mounting the 4009 IDNet
BATTERY
MOUNTING
AREA (NO
CONDUIT
ENTRY)
KNOCKOUT
SCREW/NAIL
HOLES for SEMI-
FLUSH
MOUNTING
TOP VIEW
NON-POWER-LIMITED
WIRING ONLY
C
B
D
E
A
Recommended Conduit Locations
Locate conduit entry approximately
where shown.
A. Cl
ass B or Class A Fiber Feed and
AC
Power
B. Notification Appliance Circuits
and
I
DNet
C. Class A Fiber Return
D. Notification Appliance Circuits
and
I
DNet or Class A Fiber Return
E. Co
ntrol Inputs: IDNet or
Notification Appliance Circuits