Simplex IDNet 4009-9301 - Software Address;Configuration Switch SW2

6
Figure 4. 4009 IDNet System Board
Software Address/Configuration DIP Switch SW2
The Software Address/Configuration Switch (SW2) is an 8-position DIP switch.
T
he Software Configuration/Address Switch is located at the top edge of the
system board. When the 4009 IDNet is operating as a addressable IDNet
peripheral, this switch sets the IDNet address to which the 4009 IDNet responds.
Each 4009 IDNet has a unique address (1 through 250). The address of the 4009
IDNet is set via the eight-position dip switch SW2, DIP switch position 1 is the
least significant bit (LSB) and position 8 is the most significant bit (MSB). Set
the 4009 IDNet address using Figure 5 as reference. Use a small screwdriver or
pen to set the switches.
Continued on next page
4009 IDNet NAC Extender, Continued
System Switches and
Indicators, continued
TB1, TB2
HARDWIRED NAC
(NAC 1-4)
SW2 SOFTWARE
ADDRESS/CONFIGURATION
DIPSWITCH
TB4
IDNet CONTROL INTERFACE
P4
4-CIRCUIT NAC
OPTION CARD
INTERFACE
P6
IDNet REPEATER
CARD or FIBER
RECEIVER CARD
H1 (RED WIRE), H2 (BLACK WIRE)
MAIN POWER INPUTS FROM
BRIDGE RECTIFIER
TB7
BATTERY TERMINAL
P8 (ORANGE WIRE)
P9 (YELLOW WIRE)
CHARGER INPUTS
FROM TRANSF0RMER
P7 SIGNAL POWER TO
NAC OPTION CARD
TB5
NAC CONTROL
INTERFACE
(HOST NAC IN)
TB6
AUXILARY POWER
OUTPUT
(1 AMP AVAILABLE)
P1 AND P2
CLASS A ADAPTER
INTERFACE
LED(s) 5-8
SYSTEM TROUBLE
INDICATORS
LED 9
AC POWER
INDICATOR
LED(s) 1-4
NAC STATUS
INDICATORS
BROWNOUT
ADJUSTMENT
(
SEE NOTE
)
CHARGER
(SEE NOTE)
NOTE: BROWNOUT AND CHARGER ARE FACTORY ADJUSTMENTS, DO NOT MAKE FIELD ADJUSTMENTS ON THESE COMPONENTS.
SW1
HARDWARE CONFIGURATION
DIP SWITCH