Simplicity 1695296 - Change Engine Oil; Change Engine Oil & Filter

21
Regular Maintenance
Figure 13. Recommended Engine Oil -
Briggs & Stratton Models
Use oil classified API Service Class SF,
SG, SH, SJ or better with SAE Viscosity:
10080604020 320-20
3827164-7
0-18-30
˚F
˚C
30 Conventional**
Synthetic 5W-30, 10W-30
5W-30
10W-30
Conventional*
*CAUTION: Air cooled engines run hotter than automotive engines.
The use of non-synthetic multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40º F (4ºC) will result in higher than normal
oil consumption. When using a multi-viscosity oil, check oil level
more frequently.
**CAUTION: SAE 30 oil, if used below 40º F (4ºC), will result in hard
starting and possible engine bore damage due to inadequate
lubrication.
Change Engine Oil
BRIGGS & STRATTON MODELS
Oil Capacity: Approximately 1-7/8 quarts (1.8L) without
filter change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off and
allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 11 or
12) and oil drain valve (A).
2. Drain engine oil.
3. Fill the crankcase with oil. See Check Engine
Oil Level.
Change Engine Oil & Filter
BRIGGS & STRATTON MODELS
Oil Capacity: Approximately 2 quarts (1.9L) with oil filter
change.
NOTE: Change engine oil while the engine is warm. Run
the engine for a few minutes, then shut the engine off and
allow it to cool from hot to warm.
1. Clean the area around the dip stick (C, Figure 11 or
12) and oil drain valve (A).
2. Drain engine oil.
3. Remove the oil filter (B). Discard the filter.
4. Using a drop of oil on your finger tip, wet the rubber
gasket on the bottom of the new filter.
5. Turn the filter clockwise until the rubber gasket meets
the filter base. Then turn 1/2 to 3/4 turn more.
6. Fill the crankcase with oil. See Check Engine
Oil Level.
7. Test run the engine to check for leaks. Stop the
engine for 1 minute, then recheck the oil level.
Not for
Reproduction