What causes the rider drive belt to slip on a Simplicity 5101604?
If the drive belt on your Simplicity Lawn Mower is slipping, it might be due to greasy or oily pulleys or belt, so clean as required. Alternatively, the tension might be too loose, so adjust the spring tension. Finally, the belt might be stretched or worn, so replace the belt.
Why is the engine exhaust black on my Simplicity 5101604 Lawn Mower?
If the engine exhaust of your Simplicity Lawn Mower is black, it could be due to a dirty air filter. Replace the air filter. Alternatively, the engine choke control might be in the CLOSED position; in that case, open the choke control.
How to prevent Simplicity 5101604 from scalping my lawn?
If your Simplicity Lawn Mower is scalping your lawn, consider the following: * If the lawn is uneven or bumpy, roll or level it. * If the mower deck cutting height is set too low, raise the cutting height. * If the ground speed is too fast, slow down. * If the deck is not leveled correctly, correctly level the deck. * If the tire pressure is low or uneven, check and inflate the tires.
Why is my Simplicity Lawn Mower vibrating excessively?
If you're experiencing excessive vibration with your Simplicity Lawn Mower, check the following: * Ensure the blade mounting bolts are tightened to 70 ft.lbs (94 Nm). * Inspect the mower blades, spindles, or pulleys for bending and replace as needed. * Check if the mower blades are out of balance and balance them after sharpening. * Verify that the belt is installed correctly and reinstall if necessary.
How to troubleshoot uneven cutting with a Simplicity Lawn Mower?
If your Simplicity Lawn Mower is cutting unevenly, several factors could be responsible: * The deck may not be leveled correctly, so level the deck correctly. * The blades may be dull or worn, so sharpen or replace the blades. * The blades may be damaged, so replace the blades. * The deck may be clogged with grass clippings, so clean out the deck. * The deck shell may be damaged, so repair or replace the deck. * The mower spindle may be bent or loose, so repair or replace the spindle. * The blades may be installed incorrectly, so reinstall the blades correctly. * The tires may not be properly inflated, so check and inflate the tires.
What to do if Simplicity Lawn Mower engine stalls when mower is engaged?
If your Simplicity Lawn Mower engine stalls easily when the mower is engaged, it could be due to several reasons: * The engine speed might be too slow, so set it to full throttle. * The ground speed might be too fast, so decrease it. * The cutting height might be set too low, so cut tall grass at maximum cutting height during the first pass. * The discharge chute might be jamming with cut grass, so cut grass with the discharge pointing towards the previously cut area.
How to fix streaking with Simplicity 5101604 Lawn Mower?
If your Simplicity Lawn Mower is leaving streaks, consider these possible causes: * The blades might not be sharp, so sharpen them. * The blades might be worn down too far, so replace them. * The engine speed might be too slow, so always mow at FULL throttle. * The ground speed might be too fast, so slow down. * The deck might be plugged with grass, so clean out the mower. * You might not be overlapping cutting rows enough, so overlap your cutting rows. * You might not be overlapping enough when turning, so remember that when turning your effective cutting width decreases—overlap more when turning.
General| Engine | Briggs & Stratton |
|---|---|
| Cutting Width | 22 in (56 cm) |
| Number of Blades | 1 |
| Starter Type | Recoil |
| Engine Type | 4-Cycle |
| Wheel Size | 8 inches |
| Fuel Type | Gasoline |
| Fuel Tank Capacity | 1.0 qt (0.95 L) |
Essential safety rules, operation basics, children, transporting, storage.
Covers slope operation, thrown objects, moving parts.
Covers roll bar use, obstacles, fuel and enclosed areas safety.
Covers general operation, transport, storage, maintenance safety, interlocks.
Explains safety decals, icons, and seat belt inspection.
Locating product ID numbers and key technical specifications.
Describes major controls like lift, brake, choke, PTO.
Explains ignition, throttle, speed levers, seat belt, etc.
Covers initial checks and safety.
Covers zero-turn driving, forward/reverse, and turning.
Details on setting cutting height, mowing techniques, and lawn care.
Covers raising/lowering the roll bar and unit storage.
Overview of maintenance tasks and refueling procedures.
Procedures for oil, filters, hydraulic fluid, and battery.
Servicing mower blades, belts, and brakes.
Covers control levers, suspension, deck, and lubrication points.
Common problems and remedies for the rider and mower.
Diagnosing and fixing issues affecting grass cutting quality.
Engine, transmission, dimensions, and additional manual information.
To Next Page