Simplicity 6500 Series

To Next Page

How to use this file...(Labels & Miscellaneous Documents)

————————————————————————————————————————————–––

Instructions for

Print Vendors (Paper Manuals)

Paper: * Various...

Press: * Various...

Bindery: * Various...

General: * This instruction page is NOT part of the document and must NOT be printed.

• Pages labeled with the text “THIS PAGE INTENTIONALLY BLANK” are placement pages ONLY,

and should NOT be printed.

• THIS document will most likely be a unique piece -- either a label or certificate or

other such miscellaneous format.

• EXACT specifications on the print & job specs should already be known to

you. In you are uncertain of what these specifications are, please contact

Simplicity Technical Publications.

• (Note: We will do our best to answer your questions concerning this job, but may need to transfer

you to another department within our company for additional specifications and job

requirements).

————————————————————————————————————————————–––

If you have further questions on how to utilize this file, please contact

Simplicity Technical Publications Department at (262) 284-8647.

Main Page

Need help?

Do you have a question about the Simplicity 6500 Series and is the answer not in the manual?

Summary

Introduction and Safety Guidelines

General Safety Precautions

Essential safety advice and warnings for operating and maintaining the equipment.

Section 1. Commercial Front-Cut Rider with Dual Eaton Model 7 Hydrostatic

Forward & Reverse Travel Stop Adjustments

Section 2. Large-Frame Tractors with Shaft Drive - Sundstrand Model 15 Hydrostatic

Section 3. Large-Frame Tractors with Belt Driven - Sundstrand Model 15 Hydrostatic

Section 4. Tractors with Tuff Torq K215-A & HydroGear (Sundstrand) Hydrostatic, BDU-21 L

Early Model Neutral Adjustment

Procedure for adjusting neutral on early models with Tuff Torq K215-A.

Late Model & Kit Neutral Adjustment

Neutral adjustment for late models or those with the 1686602 kit.

Section 4 (Continued): Tractors with HydroGear 216-3010 L Hydrostatic Transaxle

Section 5. Tractors with Eaton 850 Transaxle

Section 6. Tractors with Tuff Torq K60 Hydrostatic Transaxle

Section 6 (Continued): Tractors with HydroGear 311-0750;311-0800 Transaxle

Section 7. Lawn Tractors with HydroGear (Formerly Agri-Fab) Sundstrand BDU10 S Transaxle

Neutral Adjustment (Two Ball Joints)

Neutral Adjustment (One Ball Joint)

Section 7 (Continued): Lawn Tractors with HydroGear 310 - 0500 Transaxle (With Hand Control)

Section 7 (Continued): Lawn Tractors with HydroGear 318-0500;322-0500;322-0650 Transaxle (With Foot Control)

Section 8. Lawn Tractors with Eaton Model 7 Hydrostatic & Peerless 1300 Series Transaxle

Section 9. Later Model Front-Cut Rider with Eaton Model 7 Hydrostatic

Section 10. Early Model Front-Cut Rider with Eaton Model 7 Hydrostatic

Section 11. Mid-Engine Riding Mowers with HydroGear 311-0500

Neutral Adjustment Procedures

Adjusting neutral for mid-engine riders with HydroGear 311-0500 transaxle.

Return-to-Neutral Adjustment