H-20
Foot pedal adjustment
1. Disengage the PTO, stop the engine, block the
wheels, and remove the ignition key. DO NOT engage
the parking brake.
2. Measure the distance between the bottom of the forward
ground speed pedal and the foot rest. There should be
7,5 cm (3") clearance. If not, proceed to step 3.
3. Loosen the carriage bolt and nut (B) at the rear of the
transmission control rod (A).
4. Place a 7,5 cm (3") thick wood block under the forward
ground speed pedal. While holding the pedal against the
wood block, tighten the nut (B).
7,5 cm
(3 inches)
A
B
To Previous Page
Loading...
