Simplicity Baron - Page 88

E-16
Check mower blade timing (continued)
3. Use a block of wood (H) to prevent blade rotation while
loosening the capscrew (G).
4. Remove the capscrew (P), spring washer (O), spline
washer (N) and flat washer (M).
5. Remove the alignment pin (L). Rotate the blade (K)
manually until the blades (F) are perpendicular to each
other as shown.
6. Reinstall the alignment pin (L), flat washer (M), spline
washer (N), spring washer (O) and capscrew (P). Use a
wooden block (H) to prevent blade rotation while tightening
the capscrew (G) to 61-75 N.m (45-55 ft. lbs.).
F
P
O
N
M
L
K
J
G
H