man-en-smx-rns02.docx
© 2020 SIMPLINX
7.3. Installation of SMX-N1559 USB Wi-Fi Module (Optional)
Place and tighten the antenna if it is un-mounted.
Plug the USB Wi-Fi module into an empty USB slot on the SMX-RNS02.
Your SMX-N1559 module is ready for use
7.4. Ethernet Connection with PC (Service IP) (Optional)
There are three methods to access the device settings.
Connection over Wi-Fi
Physical connection from the service port with Ethernet Cable
After a remote connection is made, by accessing the web interface
If you have a Wi-Fi module and want to make settings over Wi-Fi, you can skip this step.
Connect one end of the Ethernet Cable to the SMX-RNS02 LAN port (one of the 2 ports at the
bottom), and the other end to your PC's Ethernet port.
Go to Ethernet Adapter settings on your PC
Double-press on your adapter to go to the detail page
Press the Properties button
Double-press" Internet Protocol Version 4 (TCP/IPv4)" option
Select "Manual IP Adjustment" from the page that opens and enter the following information
IP : 192.168.169.100
Subnet Mask: 255.255.255.0
Close by confirming changes
To Next Page
Loading...