STEP 4
Untwist and straighten the wire conductors. We recommend using the Simply45
Adjustable LAN Cable Stripper (S45-S01BL/YL) that has a wire straightener comb on
the top. Next, align the wires in the correct alignment pattern (Type A or B).
The B pattern is the most used today.
STEP 5
Using the S45-801 Flush Cutter, trim
the solid wires back about 3/4” (2cm).
STEP 6
Following the pattern above, insert
the 4 striped wires first. Make sure the
wires are fully laid into the load bar.
T568A
GR BL
T568B
WO WG
WBL
WBR
WG
TOP ROW
BOTTOM ROW
WO
WBL
WBR
To Next Page
Loading...