7
Quick Release
Tether Placement
The Quick Release Tethers
should be Velcro’d to the chin
bar of the helmet.
NEVER attach the tethers
to the seat belts or the car.
Side Stabilizing Gusset Adjustment
1) With the driver still properly seated in the
seat, and after adjusting the forward tethers
with the side gussets unhooked, hold the side
gusset up to the D-Ring (see picture 1).
2) With the D Ring angled down at a 45 de-
gree angle, check to see that the side gusset
is 0-3/4” below the bottom of the wire loop,
and adjust the strap accordingly to meet
these guidelines (see picture 2).
3) Now slide the Quick Release tether
through the side gusset and onto the Quick
Release (see picture 3).
Picture 1
Picture 2
Picture 3
WARNING: This article is sold without warranty, expressed or implied. No warranty or representation
made as to this products ability to protect the user from any injury or death. The user assumes that risk.
To Previous Page
Loading...