Simpson PS4240 - Quick Start Guide; Start the Engine

9 - ENG
4
Connect Spray
Wand to Spray
Gun
Thread the spray
wand into the end
of the spray gun.
5
Connect QC
Nozzles to
Spray Wand
Pull quick connect
coupler back and
insert nozzle. Release
quick connect coupler
and twist nozzle
to make sure it is
secure in coupler.
6
Turn Water
Faucet
Completely On
Do not run the
unit without water
supply connected
and turned on. Use
Cold Water Only.
7
Release Air
from System
Release all
air from pump and
high pressure hose
by depressing trigger
until a steady stream
of water is present.
Approximately
30 seconds.
30 S
8
Verify the Fuel
Switch is
turned to the
ON Position
9
Verify the
Engine Switch
is turned to the
ON Position
OFF
ON
10
Move the
Choke to the
CLOSED
Position
WARNING: This Guide is not a substitute for reading the operator's manual.
User must read and understand operator's manual before using this product.
11
Pull the Recoil
Starter Grip
Pull the
recoil starter grip to
start the engine.
12
Move the
Choke to the
OPEN Position
Gradually move
the Choke to the
OPEN Position after
engine starts.