How to fix Simpson Pressure Washer engine that will not start?
If your Simpson Pressure Washer engine won't start, try these steps: * Add fresh fuel to the tank. * Squeeze the gun trigger to relieve any built-up pressure. * Ensure the choke lever is in the "Choke" position. * Attach the spark plug wire securely.
Why is my Simpson PS60841 Pressure Washer having no or low pressure on initial use?
To resolve low or no pressure with your Simpson pressure washer upon initial use: 1. Make sure the spray wand is set to high pressure. 2. Ensure a sufficient water supply (at least 5 gpm @ 20 PSI). 3. Repair any leaks at the high-pressure hose fitting, using sealant tape if needed. 4. Address any nozzle obstructions. 5. Clean the water filter screen. 6. Remove air from the hose by disconnecting it from the pump inlet, turning on the water source until a steady stream appears, then reconnecting and squeezing the trigger. 7. Ensure the choke is in the “No Choke” position. 8. Use a high-pressure hose under 100 feet (30 m).
What to do if my Simpson PS60841 Pressure Washer will not draw chemicals?
If your Simpson Pressure Washer isn't drawing chemicals, consider these solutions: * Ensure the spray wand is set to low pressure. * Clean the chemical filter. * Make sure the detergent siphon hose is fully submerged in the cleaning solution. * Dilute the chemical if it's too thick, aiming for a water-like consistency. * Use a longer water supply hose instead of a high-pressure hose.
How to fix water leaking at gun/spray wand connection of Simpson PS60841 Pressure Washer?
If you notice water leaking at the gun/spray wand connection of your Simpson pressure washer: * Inspect the o-ring for wear or tears and replace it if necessary. * Tighten any loose hose connections.
Why is there oil leaking at the pump of my Simpson PS60841 Pressure Washer?
If there's oil leaking at the pump of your Simpson pressure washer, try the following: * Tighten any loose drain plugs. * Check and replace any worn drain plug o-rings. * Check and replace any worn fill plug o-rings. * Verify the oil level is correct. * If incorrect oil was used, drain and refill with the correct type and amount. * Clean the vent plug by blowing air through it; replace if the problem continues. * Clean and/or replace the air filter element.
General| Power Source | Gasoline |
|---|---|
| Max Flow Rate | 2.5 GPM |
| CC | 196cc |
| Hose Length | 25 ft |
| Frame Material | Steel |
| Motor | NA |
| Nozzle Types | 0°, 15°, 25°, 40°, Soap |
| Pump | OEM Technologies Axial Cam |
Key advisories on fuel, customer service, and manual retention.
Explanation of safety symbols and CO risks.
Dangers of fluid injection and California Proposition 65 notice.
Guidance on preventing fire and explosion risks associated with fuel.
Dangers of exhaust fumes and high-pressure fluid injection.
Safety measures against injury from spray and projectiles.
Guidelines for safe operation and preventing accidents.
Precautions for transport, electrical shock, and chemical burns.
Warnings about tire bursting, hot surfaces, and safe lifting practices.
Steps for handle installation, fluid checks, and hose connections.
Final steps for attaching accessories and starting the engine.
Identification of main pressure washer parts and their functions.
Step-by-step guide for assembling the pressure washer.
Definitions and methods for adjusting water pressure.
Guide on choosing and changing spray nozzles for different tasks.
Instructions for using cleaning chemicals with the pressure washer.
Critical safety warnings before starting the engine.
Procedures for fueling, checking oil, and connecting the water source.
Steps for starting the engine, running, and shutting down the unit.
Guidance on checking and changing oil, and cleaning nozzles.
Cleaning the filter and preparing fuel for storage.
Using pump guard and reviewing product specifications and accessories.
Details on warranty terms, exclusions, and durations by component.
Solutions for issues like no start or low pressure.
Diagnosing and fixing leaks, pump pulsation, and chemical draw problems.
Visual guide to common replacement parts for the pressure washer.
Company contact information and assembly origin details.
To Next Page
